Ableton Push 3 Launchpad Midi Daw Controller Tabletop Desktop Studio Stand
£21.99
Designed for use with the Akai Push / Ableton Push 2 / DAW Midi controller.
Our sturdy designs offer the best in ergonomic style and desktop studio space saving design according to the users chosen angle and allows easier use of hands on control
and a better viewing angle for screens and control labels etc.
These stands support the entire rear of the device and to a width of 300mm using our triple braced system.
Suitable for a range of DAW Controllers and studio equipment
Where applicable all stands have solid rubber anti-skid feet and soft anti-slip rubber pads on their surfaces to keep your gear where it should be... safe!
Because we don't just make plastic triangles, we also care, not only about your instruments, but also the world at large.
Our new studio workshop in Ireland is powered by a combination of solar and wind.
Our raw materials (PLA) are mostly plant based and bio-degradable.
All items are made to order using 3D printing technology in our studio workshop, please allow up to 5 days for despatch during busy periods.
Instructions for assembly included. These are SUPER TIGHT snap fit stands. We recommend placing the strut braces on the corner of a hard surface and pushing the frame slot down firmly onto the tab to assemble. Should you have any questions or issues with the fitting of the braces then please message us as we're always happy to help!
Designed for use with the Akai Push / Ableton Push 2 / DAW Midi controller.
Our sturdy designs offer the best in ergonomic style and desktop studio space saving design according to the users chosen angle and allows easier use of hands on control
and a better viewing angle for screens and control labels etc.
These stands support the entire rear of the device and to a width of 300mm using our triple braced system.
Suitable for a range of DAW Controllers and studio equipment
Where applicable all stands have solid rubber anti-skid feet and soft anti-slip rubber pads on their surfaces to keep your gear where it should be... safe!
Because we don't just make plastic triangles, we also care, not only about your instruments, but also the world at large.
Our new studio workshop in Ireland is powered by a combination of solar and wind.
Our raw materials (PLA) are mostly plant based and bio-degradable.
All items are made to order using 3D printing technology in our studio workshop, please allow up to 5 days for despatch during busy periods.
Instructions for assembly included. These are SUPER TIGHT snap fit stands. We recommend placing the strut braces on the corner of a hard surface and pushing the frame slot down firmly onto the tab to assemble. Should you have any questions or issues with the fitting of the braces then please message us as we're always happy to help!
