Shop › NEW* Wall Mounted Synthesiser Arms Music Studio Brackets - Pair *Right-angled* NEW* Wall Mounted Synthesiser Arms Music Studio Brackets - Pair *Right-angled* £23.99 Wall Mounted Synthesiser Drum machine Sampler etc Arms Music Studio Stand...Build your own wall mounted Jaspers rack equivalent!Suitable for a wide range of gear up to approx 275mm total depth.Bracket Lip is 18mm, and heavily reinforced. please check this dimension with the suitability of your equipment.For heavier items we recommend using multiples of arms, additional arms can also be provided.Arms also available at a steeper angled 45 % 55°Bolt holes are 6mm diameter with a 10mm washer indent. Fittings not included, recommended using secure wall anchors/plugs and tightening down by hand.Mounted with anti-slip pads on the arm face and lip edge for additional grip.Because we don't just make plastic triangles, we also care, not only about your instruments, but also the world at large. Our new studio workshop in Ireland is powered by a combination of solar and wind. Our raw materials (PLA) are mostly plant based and bio-degradable.All items are made to order using 3D printing technology in our studio workshop, please allow up to 5 days for despatch during busy periods.These arms are made, and used, by ourselves, using high quality PLA. Printed to a layer height of 0.16 mm with a high density infill.Smaller arms now also available!Please check our other listings for great value studio solutions.Many thanks Wall Mounted Synthesiser Drum machine Sampler etc Arms Music Studio Stand...Build your own wall mounted Jaspers rack equivalent!Suitable for a wide range of gear up to approx 275mm total depth.Bracket Lip is 18mm, and heavily reinforced. please check this dimension with the suitability of your equipment.For heavier items we recommend using multiples of arms, additional arms can also be provided.Arms also available at a steeper angled 45 % 55°Bolt holes are 6mm diameter with a 10mm washer indent. Fittings not included, recommended using secure wall anchors/plugs and tightening down by hand.Mounted with anti-slip pads on the arm face and lip edge for additional grip.Because we don't just make plastic triangles, we also care, not only about your instruments, but also the world at large. Our new studio workshop in Ireland is powered by a combination of solar and wind. Our raw materials (PLA) are mostly plant based and bio-degradable.All items are made to order using 3D printing technology in our studio workshop, please allow up to 5 days for despatch during busy periods.These arms are made, and used, by ourselves, using high quality PLA. Printed to a layer height of 0.16 mm with a high density infill.Smaller arms now also available!Please check our other listings for great value studio solutions.Many thanks Add To Cart Added!
